Getting FAIL WHALE! screen in login into backoffice

mohammed.shamim
mohammed.shamim Posts: 35 🧑🏻‍🚀 - Cadet
edited May 16 in Spryker Dev Environment

I m getting this issue from this week, whenever I start the container using debug code like docker/sdk restart -x then backoffice login url show Fail whale screen , after trying refresh several times , login successful but again in accessing links in backoffice and during logout land to same FAIL WHALE screen.

But if i use command without debug mode like docker/sdk restart , then all works well!

Comments

  • fsmeier
    fsmeier Senior Software Engineer & Developer Enablement Advocate Sprykee Posts: 1,084 ⚖️ - Guardians (admin)

    Heyhey, sounds like the same like described here:

    All the best,

    Florian

  • mohammed.shamim
    mohammed.shamim Posts: 35 🧑🏻‍🚀 - Cadet

    but as far as i know , we are using same deploy.dev.yml file since so long, Is there any recent update that impact or conflict with blackfire!

  • fsmeier
    fsmeier Senior Software Engineer & Developer Enablement Advocate Sprykee Posts: 1,084 ⚖️ - Guardians (admin)

    Not that I know of - but I have the same and I am upset that blackfire just writes on their page that it may conflicts with xdebug stuff - but they must have introduced it at some point

  • fsmeier
    fsmeier Senior Software Engineer & Developer Enablement Advocate Sprykee Posts: 1,084 ⚖️ - Guardians (admin)

    Lets discuss this further in the other post to keep it in one place :)

    I close the thread here.

This discussion has been closed.